Material Dealing with Electrical power UNIT 2
This energy unit attributes energy up gravity down circuit. Activate the begin solenoid to begin the motor to lift the machine. The lowing movement is activated through the solenoid valve together with the reducing speed managed from the pressure compensated movement handle valve. Goods of this series could be widely used in the sector of logistic products such as fork lift, mini lift table, and so on.
one. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all of the hydraulic components concerned prior to mounting the energy unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst,which need to also be clean and no cost of impurities, N46 hydraulic oil is proposed .
four. Oil changing is required right after the original a hundred operation hours,afterwards when every 3000 hrs.
5. The energy unit really should be mounted horizontally.
Material Handling Power UNIT one
This energy unit is made to the fork lift market, consisting of extremely effective gear pump, DC motor, guide increase and lower valve, tank, ect. The up and down motion are managed from the lever on the guide release valve, which can be equipped with an electrical switch to activate the motor. The lowing velocity is managed through the strain compensated movement management valve.
one. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean every one of the hydraulic components concerned prior to set up of the power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which must also be clean and no cost of impurities, N46 hydraulic oil is encouraged .
four. Oil modifying is needed immediately after the preliminary a hundred operation hours, afterwards as soon as every 3000 hours.
5. The electrical power unit shown is made to be mounted horizontally.