Power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Standard Description
This power unit is built solely to the modest lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit continues to be widely employed during the industry of logistic products for instance minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed from the solenoid valve with the speed controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Standard Description
This power unit is created solely for that medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and also the pace managed from the adjustable needle valve. When the lift rises to a high positoin, but the power supply is minimize, the decreasing motion is controlled through the guide override function.
Power UNITS FOR LIFT TABLE 3
Standard Description
This energy unit is designed solely for your big lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the pace controlled by a pressure compensated movement handle valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This power unit is intended exclusively for that significant lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as the speed managed by the adjustable needle valve. Once the lift rises to a large positoin, but the energy provide is minimize, the lowering motion is managed through the manual override perform.
Specific Notes
one. This power unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all of the hydraulic elements concerned just before installation of the energy unit.
3. Viscosity of the oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities.N46 hydraulic oil is recommended.
4. Oil altering is required right after the preliminary a hundred operation hours,afterwards the moment every single 3000 hours.
5. The electrical power unit shown is made to be mounted vertically.

Tags:

truck drive shaft

As one of leading truck drive shaft manufacturers, suppliers and exporters of mechanical products, We offer truck drive shaft and many other products.

Please contact us for details.

Mail:[email protected]

Manufacturer supplier exporter of truck drive shaft

Recent Posts