The best way to connect O-ring Chains Remarks to connect standard O-ring Chains

one.A connecting link of an O-ring Chain for basic application is pre-coated with grease on the pins. In advance of connection, verify the grease over the surfaces of pins, and should the quantity of grease is modest, apply grease with bare hands. (If gloves are employed, the grease will be absorbed through the gloves.)
Illustration: When the connecting website link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted at the roots of the pins. If your O-rings come loose due to vibration for the duration of transport, refit the O-rings in for the roots of the pins.
In this case, make sure you return the grease collected with the roots in the pins to your central surfaces in the pins, additional at portion A than at portions B shown from the over illustration. (Portions A is worn as a consequence of sliding with the bushings.)
two.The chain could be most easily connected within the teeth of a sprocket. Engage the hyperlinks at the two ends of the chain using the sprocket teeth and fit connecting pins. In the event the sprocket is usually moved, the chain may also be connected within the loosened side.
3. Connecting procedure
one.Verify that O-rings are attached to the roots of the pins.
2.Should the amount of grease utilized over the connecting pins is small, coat the pins with grease in the central portions.
three.Insert the connecting pins to the bushings from the inner back links at both ends.
four.Confirm the grease is utilized for the entire encounter from the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and although pressing the connecting plate, install the spring clip. Confirm no matter if the head (the finish without a split) on the spring clip is turned from the feeding path with the chain. (See the following illustration.)
six.Be sure to confirm that the spring clip is securely fitted in the clip grooves of your connecting pins.
This completes jointing from the connecting link. Note that grease about the surfaces of connecting pins and O-rings could be eliminated for the duration of set up get the job done. In this case, re-grease using the grease about the surface on the base chain or even the grease within the polyethylene bag through which the connecting hyperlink was contained.